Fastener replacement
Panels are secured with new screws before they let water in.
A Livingston roofer can fix leaks on metal, rubber and shingle mobile home roofs, working with the light framing these homes are built on. Dial (973) 858-1821 to talk through the leak with a local roofer.
A mobile home roof has its own weak points, and most leaks start at the same few spots. Many older homes have a low slope metal roof fastened over lightweight trusses, while others have a rubber membrane or, on newer homes, a pitched shingle roof. For metal roofs, panel seams, fastener holes and dried sealant at vents and the perimeter edge cause most leaks.
Water does damage quickly in a manufactured home. Thin ceiling panels stain and bow, insulation gets soaked and the wood framing can start to rot before the leak is obvious. A ceiling sagging with water can be drained through a small hole into a bucket, away from any light fixture, with power to that area shut off at the panel if the panel is safe to reach.
The framing under a mobile home roof is light, so walking it takes care. Stepping between the supports can buckle the metal or damage the ceiling, so roofers stay on the truss lines. Never go up when the roof is wet or icy, and check the data plate inside the home, which lists the roof load zone the home was built for.
If the problem goes deeper than it first looked, a Livingston roofer may also recommend roof coating or metal roof repair.
Looking for Livingston mobile home roof repair? Call (973) 858-1821 to reach a nearby roofing contractor.
Call nowA lasting repair seals the roof and deals with any water damage underneath.
From a ladder and along the truss lines, the roofer checks seams, screws, coating, edges and penetrations. Stains on the ceiling inside help narrow down the source.
Loose or stripped screws are replaced with larger fasteners that have new rubber washers, and loose panels are fastened down so they stop flexing. Rusted spots are cleaned and treated before sealing.
Seams and laps are cleaned, primed where needed and sealed. On rubber roofs, the roofer patches with matching membrane and lap sealant.
Every roof penetration is resealed, with brittle vent caps or skylight domes replaced. The edge rail around the roof is resealed too.
A reflective coating over the whole roof ties the repairs together and slows rust. The roof must be clean and dry for the coating to stick.
Panels are secured with new screws before they let water in.
Vents, skylights and the AC curb are resealed to stop leaks at each opening.
Open seams are sealed with tape or fabric and coating so water stops getting through.
A reflective coating covers the roof to seal and protect it.
Rotted sheathing or framing under leaks is repaired so the roof is solid again.
When repairs cannot keep up, a mobile home roof replacement removes the old roofing and installs a new system. Depending on the home, the new roof may be metal, a single ply membrane such as EPDM or TPO, or shingles on a pitched roof. Damaged trusses are fixed first.
A mobile home roof replacement in Livingston starts with the trusses, since the new roof has to stay within what they can carry. A permit may be required, and rules for manufactured homes can differ from site-built homes, so the roofer should check local requirements. Done right, the new roof should end the cycle of patching.
A mobile home roof over installs a new roof on top of the existing one instead of tearing it off. Options include a framed pitched roof that adds an attic space, an insulated membrane roof over, or new metal fastened over furring strips. Many roof overs add insulation, cutting heat gain and making the home quieter in storms.
For a Livingston mobile home roof over, the roofer checks the walls and trusses, since the new roof adds weight and catches more wind. A pitched roof over changes the structure, so it often needs a permit and engineering, plus solid anchoring for wind. Done well, a roof over can stop chronic leaks and add years to the home.
Around Livingston, mobile home roofs include older metal roofs, rubber membrane roofs and newer shingle roofs on pitched manufactured homes. From Livingston out to Roseland, Short Hills, Florham Park and Caldwell, most mobile home roof calls come down to seams, screws and sealant around vents, while older roofs that have leaked for years often need a roof over instead.
For mobile home roof repair in Livingston, NJ or nearby towns like Roseland, Short Hills, Florham Park and Caldwell, call (973) 858-1821 to reach a roofer who covers your street.
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Livingston is busiest after a hard winter and before the next one.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers in Livingston know the roof types and weather wear common in local homes.
Ask your questions before you agree to anything.
More questions? Call (973) 858-1821
Silicone, acrylic and other liquid coatings that renew aging flat, low-slope and metal roofs, after the seams and blisters are repaired.
Learn moreReplacing worn screws and washers, resealing panel laps, treating rust and fixing loose trim on metal roofs, matched to exposed fastener and standing seam roofs alike.
Learn moreRepairs for leaking rubber roofs, from peeling seams to pulled flashing at walls and curbs, never with tar or asphalt cement that ruins the rubber.
Learn moreFinding where water gets through the roof and sealing it at the source, with the damage underneath checked too.
Learn moreLooking for something else?
See all roofing servicesCall (973) 858-1821 for a local roofer in Livingston and nearby towns.